Honda Odyssey FL350R Front Bumper Rubber End Caps

Honda Odyssey FL350R Front Bumper Rubber End Caps

Keep moisture, trail mud, and sand out of your frame tubing with front bumper rubber end caps for the Honda Odyssey FL350R. Because original factory caps are notorious for drying out, cracking, and falling off after decades of exposure, we offer flexible modern reproductions alongside authentic OEM options based on availability.

Available Condition Options

1. High-Grade Aftermarket Reproduction (Recommended)

Our primary and most consistently available solution. These caps are painstakingly reverse-engineered to replicate the original factory profile and dimensions.

• Material: 3D-printed from high-grade, UV-resistant flexible rubber (TPU) that will not dry-rot or become brittle.
• Fit: Snug interference fit that stays seated despite engine and trail vibration.
• Finish Note: Features characteristic fine additive manufacturing layer lines, representing the highest-quality reproduction available on the market today.

2. Genuine Honda OEM – New Old Stock (Subject to Availability)

Original, unused factory Honda caps. Subject strictly to rare warehouse finds and stock availability.

• Authenticity: 100% genuine factory Honda part for strict museum-grade or numbers-matching restorations.
• Availability: Extremely limited; if shown out of stock, select our Aftermarket Reproduction.

3. Genuine Honda OEM – Used (Subject to Availability)

Original factory caps salvaged from vintage machines.

• Condition: Inspected for usability, but will exhibit cosmetic wear, slight hardening, or patina consistent with 40-year-old vintage rubber.
• Stock: Available only as donor inventory allows.

Installation Tip

Clean out any old rubber debris, rust, or dirt from the inner lip of the bumper tube before inserting new caps. A light wipe with rubbing alcohol allows the rubber to slide into place and seat flush against the tube end.